FS201-3A vibration monitor can continuously and reliably measure and analyze the low-frequency vibration of wind turbines, and outputes software and hardware alarm signals when the vibration amplitude exceeds the default value.

The FS201-3A is equipped with vibration amplitude monitoring function, vibration spectrum output function, tilt angle monitoring function, watchdog and self-inspection functions. It enables parameter configuration programming and digital output via RS485/CANopen interfaces.

FS201-3A Three-axis Vibration Monitor

Supply Voltage
Rated Power
Measuring Range
Resolution
Frequency Range
Resolution
Boot Waiting Time
Measurement Reaction Time
Alarm Delay Time
Relay Contact Load
Communication Interface
Protection Class
Operating Temperature
Size
Weight

24Vdc ± 10%
3.5W (typical, relay pick-up)
0.500g
0.001g
0.2 ~ 5.0Hz
0.01Hz
2 sec (typical)
0.5sec ~ 6sec (depending on center frequency and bandwidth setting)
0.1sec ~ 25.5sec
24V, 2A
RS485/CANopen
IP68
-40°C to +80°C
174mm × 80mm × 58mm
1.3kg (without cable)

▶  Vibration and inclination in the X, Y, and Z directions can be measured simultaneously by the accelerometers. One or more vibration monitors can be monitored.
▶  Alarm value and delay time can be settled individually.
▶  The status including Power supply, cable and accelerometer status can be monitored.
▶  All parameters including center frequency, bandwidth, alarm delay time and relay function can be settled.